Ryetec 300.50A 1204 Three Point Linkage Aeroking Vertical Tine Aerator.
Quick and effective aeration and compaction relief
•The ‘Autoheave’ system is both simple to set up and operate
•Height is controlled by interconnected handles from either the right or left hand side of machine
•three speed gearbox is standard on all models for fine control of hole spacing on tractors with 540, 750 or 1000 rpm PTO shafts.
•Machine weight can be increased by water ballasting the rollers if required
•Simple and strong engineering for maximum service life and minimum down time and servicing
•Close coupling to the tractor keeps tractor lift capacity to a minimum. An optional trailed version is available for high horsepower tractors with low lift capacity.
There are no associated products at the moment
Specification
AeroKing patent operation with ‘Autoheave’
Unlike conventional vertical tine aerators, the AeroKing’s parallel action uses a single compression spring on the top drive arm, as opposed to twin springs on the bottom arm, which can actually prevent a machine’s heave action. The heave action on the AeroKing is completely automatic and is governed by the hole spacing and tractors forward speed. The patented top spring system and irregular parallel action mean the tines are driven into the ground and start the heave action and are only assisted on the return stroke out of the ground by the single compression spring. This combined with the unique working path of the tine holder keeps the edges of the hole more uniform with less pressure on the sides of the hole, and less wear and tear on the machine.
Three ranges:
•300-50 - for tractors from 20-50hp, 1.2m and 1.65m working widths, and a lighter weight ‘A’ version for small tractors. Tine length 180/300mm (7”/12”).
•300-80 - for tractors from 35-80hp, 1.65m or 2.1m working widths, and a lighter weight ‘A’ version for small tractors. Tine length 180/300mm (7”/12”).
•400-95 - for tractors from 45-95hp, 1.7m, 2.1m and 2.5m working widths. Tine length 300/400mm (7"/12"/16”).
Solid tines range from 8-25mm (5/16-1”) in diameter and hollow tines from 16-25mm (5/8-1”) in diameter allowing for use on most turf surfaces with minimal surface disturbance.
300.50A
Working Width 1200mm
Weight Kg 480kg
No. of tine Carriers 4
Min/Max hp 25 to 50 hp
Tines
Ø x length mm No. per carrier
Solid tines
8 x 180 4* or 8***
12 x 300 4
18 x 300 2**
18 x 400† 2**
25 x 300 2
25 x 400 2
Hollow tines
16 x 175 4
19 x 255 2**
25 x 255 2**
Adaptors
from 12 to 8mm (for * above)
from 25 to 18mm (for ** above)
Multiplier
for 8 times instead of 4 (*** above)
400 mm length tines on 400.95 models only
25 to 18mm adaptor on 400.95 models only
Accessories:
•Rear roller with water ballast.
•Hydraulic trailer for transportation.
•Brushes (2) and roller for levelling sand/filling in.
•Hydraulic rotating brush and roller.
•Adjustable windrow plates for cores.
•Wide turf retaining plate for use with soft turf.
•Narrow turf retaining plate for use with soft turf.
